1. Technology
You can opt-out at any time. Please refer to our privacy policy for contact information.

Cisco Valet Plus M20 Default Password

Valet Plus M20 Default Password & Other Default Login Info

By

Looking for the Cisco Valet Plus M20 default password? You probably have little reason to access your router on a regular basis so don't feel too bad if you've forgotten the Valet Plus M20 default password.

However, when you're troubleshooting a network problem and need to get in to the device, the Valet Plus M20 default password suddenly becomes very important.

For most versions of the Cisco Valet Plus M20, the default password is admin. As with most passwords, the Valet Plus M20 default password is case sensitive.

In addition to the Valet Plus M20 default password, you can also see the Valet Plus M20 default username and Valet Plus M20 default IP address in the table below.

Note: The Cisco Valet Plus M20 default password may be different for certain hardware or firmware versions.

If I have that information, I'll include the exact Valet Plus M20 version number along with the correct default password. You can usually find your Cisco Valet Plus M20 version number on the bottom of the router.

Be sure to change the default router password on your Valet Plus M20 to something more secure as soon as you're in. Then use a free password manager so you'll never forget your new Valet Plus M20 password.

Help! The Valet Plus M20 Default Password Doesn't Work!

At some point during the life of your particular Cisco Valet Plus M20, the default password, username, and/or IP address might have been changed.

In most cases, if the Cisco Valet Plus M20 default IP address has been changed, the new IP address for the Valet Plus M20 will be the same as the default gateway IP address configured for your network connection.

See How To Find the Default Gateway IP Address for help.

In situations where the Valet Plus M20 default password or Valet Plus M20 default username has changed, you'll need to reset the Cisco Valet Plus M20 to factory defaults. You can usually do that via a special button or sequence of actions.

The Valet Plus M20 manual will have specific directions for performing a factory default reset. You can download the manual for the Valet Plus M20 from Cisco Support.

Please let me know if any of the Valet Plus M20 default login data below needs updated. For other questions about the Valet Plus M20 default information on this page, see my Default Password FAQ.

Valet Plus M20 Default Password & Other Default Login Data

Version Default Username Default Password Default IP Privileges
All admin admin 192.168.1.1 Administrator

©2014 About.com. All rights reserved.