Looking for the Cisco SRW2048 default password? You probably have little reason to access your switch on a regular basis so don't feel too bad if you've forgotten the SRW2048 default password.
However, when you're troubleshooting a network problem and need to get in to the device, the SRW2048 default password suddenly becomes very important.
For most versions of the Cisco SRW2048, the default password is [none]. In other words, there is no SRW2048 default password and you should leave the field blank when asked for a password.
In addition to the SRW2048 default password, you can also see the SRW2048 default username and SRW2048 default IP address in the table below.
If I have that information, I'll include the exact SRW2048 version number along with the correct default password. You can usually find your Cisco SRW2048 version number on the bottom of the switch.
Help! The SRW2048 Default Password Doesn't Work!
At some point during the life of your particular Cisco SRW2048, the default password, username, and/or IP address might have been changed.
For most networks, if the Cisco SRW2048 default IP address has been changed, the new IP address for the SRW2048 switch can be determined using tracert, a command available from the Command Prompt in Windows.
See How To Identify Network Hardware IP Addresses on a Local Network if you need help using tracert to find the SRW2048 default IP address.
In situations where the SRW2048 default password or SRW2048 default username has changed, you'll need to reset the Cisco SRW2048 to factory defaults. You can usually do that via a special button or sequence of actions.
The SRW2048 manual will have specific directions for performing a factory default reset. You can download the manual for the SRW2048 from Cisco Support.
SRW2048 Default Password & Other Default Login Data
|Version||Default Username||Default Password||Default IP||Privileges|